Overload Protection; Overheat Protection - Makita DVC660 Manuel D'instruction

Masquer les pouces Voir aussi pour DVC660:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Appliance / battery protection system
The appliance is equipped with a appliance / battery protec-
tion system. This system automatically cuts off power to the
motor to extend appliance and battery life. The appliance
will automatically stop during operation if the appliance or
battery is placed under one of the following conditions:

Overload protection

When the appliance is operated in a manner that causes it to
draw an abnormally high current, the appliance automatically
stops without any indication. In this situation, turn the appli-
ance off and stop the application that caused the appliance to
become overloaded. Then turn the appliance on to restart.

Overheat protection

When the appliance is overheated, the appliance
stops automatically, and the LED light blinks about 60
seconds. In this situation, let the appliance cool down
before turning the appliance on again.
While the LED light is blinking, you can turn off the LED
light by pressing
button.
► 1. LED light
Overdischarge protection
When the battery capacity becomes low, the appliance
stops automatically. If the product does not operate
even when the switches are operated, remove the bat-
teries from the appliance and charge the batteries.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► 1. Indicator lamps 2. Check button
1
1
2
7 ENGLISH
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch box position
The switch box can be hooked on either side of the
lower belt. Arrange the cord so that the switch box
comes to your desired side. To prevent the cord from
being damaged, pass the cord through the groove as
illustrated.
1
2
► 1. Groove 2. Cord
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1
2

Publicité

Table des Matières
loading

Table des Matières