Makita DVC660 Manuel D'instruction page 18

Cleaning the clog
When cleaning the clog, remove the hose or the exten-
sion wand, or the bent pipe assembly to check inside.
Removing/attaching the snap-on type bent pipe
assembly
To remove, pull the bent pipe assembly while pressing
both of the tab on the hose end.
To attach, insert the hose end into the bent pipe assem-
bly. Make sure that the tabs on the hose end snap into
the holes on the bent pipe assembly.
1 2
► 1. Hose end 2. Tab 3. Hole 4. Bent pipe assembly
Removing/attaching the screw-in type bent pipe
assembly
To remove, loosen the sleeve of bent pipe assembly
from the hose.
To attach, fasten the sleeve of bent pipe assembly onto
the hose.
1
► 1. Hose 2. Bent pipe assembly 3. Sleeve
4
3
2
3
18 ENGLISH
Cleaning the room for filter bag/
dust bag
When cleaning the room for filter bag/dust bag, remove
and wipe the board inside.
► 1. Board
Removing the board
1. Remove the HEPA filter. Refer to the section for
cleaning the HEPA filter for how to remove.
2. Push down the board, and slide it to left until the
board touches the wall.
3. Lift the right side of the board up and take it out.
► 1. Board
1
1