Cleaning And Maintenance; Washing Instructions - Babyauto Ezcon Notice D'utilisation

6. CLEANING AND MAINTENANCE

Removing the buckle protector and the lower harness
1. Locate the harness metal connector
2. Unhook both harness straps to release them from the connector
at the rear of the backrest (6.2).
3. Insert the strap into the grooves of the seat backrest and seat
cover (6.3).
Removing the buckle protector and the lower harness
1. Locate the safety buckle plate on the base of the seat (6.4).
2. Turn the plate of the belt safety buckle so that it matches the
groove and insert in the groove at the base of the seat and then
through the slots in the seat cover removing the safety buckle
from the seat (6.5).
3. Pull the straps at the base of the seat to remove them from the
seat, making sure the seat belt connectors are loosened as shown
in the instructions (6.6).
Cleaning the seat
1. Wash the straps and plastic parts with neutral detergent and
warm water.
2. Ensure that no soap enters the buckle or metal parts.
3. Do not use chemicals or bleach on any part of the chair.
4. Dry thoroughly before use.
If you have any question about using or installing this product, or if you need a
spare part contact our Customer Service.
Group 1/2/3
R at the back of the seat (6.1).

WASHING INSTRUCTIONS:

· The cover is removable and washable at 30º.
Dry in the fresh air only.
· Wash in washing machine (cold).
· Do not use bleach.
· Dry clean, with any solvent except
trichloroethylene.
· Do not use dryer.
· Do not iron.
www.babyauto.com
EN
25