Babyauto Ezcon Notice D'utilisation page 23

5. ADJUST THE HARNESS TO THE HEIGHT OF THE CHILD.
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (5.1).
Changing the harness height
1. Adjust the height of the harness, by pressing the harness
adjustment button and pulling the harness straps towards you to
loosen them (5.2).
2. Place your hand on the headrest and press the lever
the seat down with the other hand so it does not move (5.3).
3. Then unhook one of the harness connector straps at the back of
the seat and pull the loose strap towards the front of the seat (5.4).
4. Insert the harness strap into the
at the front of the seat. Then insert the harness strap into the
appropriate upper or lower slot at the rear of the seat (5.5).
5. Reinsert the harness strap in the harness connector on the back
of the seat (5.6).
6. Then, do the same with the other harness strap. Verify that the 2
harness straps go through the slots at the same height. Do not use
the upper guides of the child seat. These should only be used to
guide the vehicle's safety belts.
Fastening the harness
1. Join the 2 buckle metal connectors (5.7).
2. Pass both connectors through the slot in the upper part of the
buckle until you hear a "click" (5.8).
3. Always make sure the harness is properly fastened by pulling the
harness straps upwards (5.9).
4. To unfasten the harness press the red button on the buckle
downwards (5.10).
Group 1/2/3
O slot of the fabric and backrest
M while pulling
www.babyauto.com
EN
23