Babyauto Ezcon Notice D'utilisation page 22

4. Make sure the vehicle's safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle's
safety belt or prevent the installation of the seat in any way. To
release your child unbuckle the vehicle safety belt as described in
the instructions.
When the seat is being used for group 1, the seat belt must pass
through the slot in the headrest and this should be in the lowest
position.
4. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 2 AND 3.
WARNING
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps as shown in Chapter 6.
1. Place the child seat on the seat of the vehicle, ensuring it is pressed
firmly against the back of the vehicle seat (4.1).
2. Place the child in the child car safety seat (4.2).
3. According to the child's height the headrest can be adjusted up or
down. Place your hand on the headrest and press the lever while
pulling the seat down with the other hand so it does not move
(4.3).
4. Pass the diagonal seat belt trough guide
and the lap seat belt through guides
that the seat belts are not twisted and tighten by pulling the
diagonal seat belt upwards (4.4, 4.5, 4.6 and 4.7).
5. Attach the seat belt to the vehicle anchor point and press until you
hear a "click" that lets you know that the child seat is properly
installed (4.8).
6. Make sure the vehicle's safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle seat
belt or prevent the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as described in the
instructions.
Ensure that the belt is well tightened.
22 Child restraint system
Use Group 2 and 3 only from approx.
4 to 12 years of age (15-36 kg)
B located in the headrest
J under both armrests. Check
EZCON