Onkyo HT-R993 Mode D'emploi page 18

1 2 3 4
8 9 F
Rear Panel
1
RI REMOTE CONTROL jack: An Onkyo product with RI
jack can be connected and synchronized with this unit.
2
#06'00# #/(/  : The supplied antennas are
connected.
3
COMPONENT VIDEO IN/OUT jacks: Component video
input/output jacks.
4
ETHERNET port: Used for Ethernet connection.
5
HDMI IN/OUT jacks: Digital video signals and audio
signals are transmitted between the unit and the
connected devices.
6
SPEAKERS terminals: Speakers are connected. To
use the multi-zone function, connect the speakers in the
separate room to the SPEAKERS ZONE2 terminals.
7
Power cord
8
DIGITAL IN COAXIAL/OPTICAL jacks: Digital audio
signals are input.
9
GND terminal: The ground wire of the turntable is
connected.
F
COMPOSITE VIDEO/AUDIO IN jacks: Analog video
signals and audio signals are input.
G
MONITOR OUT V jack: Video signals are output to the
connected monitor or TV via a composite video cable.
18
5
G H I
H
LINE OUT ZONE2 jacks: Audio output jacks connected
to the integrated amplifier for multi-zone playback in a
separate room.
I
PRE OUT SUBWOOFER jacks: A subwoofer with built-
in amplifier is connected.
6 7 1 23
Display
1
Lights in the following conditions. "Z2": ZONE 2 output
is on. / "HDMI": HDMI signals are input and HDMI input
selector is selected. / "ARC": Audio signals are input
from ARC compatible TV and TV/CD input selector
is selected. / "3D": Input signals are 3D. / "USB" (¼):
"USB" input is selected and USB storage device is
connected. / "NET" (¼): "NET" input is selected and
the unit is connected to the network. / "DIGITAL":
Digital signals are input and the digital input selector is
selected. / Cursor indicators: NET or USB is controlled.
¼ "USB" and "NET" will flash if the connection is not correct.
2
Stays lit when headphones are connected.
3
Lights when NET or USB is controlled.
4
Lights according to the type of input digital signals and
the listening mode.
5
Stays lit when Music Optimizer is enabled.
6
Lights in the following conditions. "AUTO": Tuning mode
is auto. / "fTUNEDe": Receiving AM/FM radio. fe
flashes while tuning is automatically performed. /
"FM STEREO": Receiving FM stereo. / "RDS"
(European models): Receiving RDS broadcasting.
7
"MUTING": Flashes when muting is on.
8
Lights in the following conditions. "SLEEP": Sleep
timer has been set. / "ASb": Auto Standby is on. / "ch":
Channel is being set. / "Hz": Crossover frequencies are
being set. / "m/ft": Speaker distances are being set. /
"dB": Speaker volume is being set.
9
Displays various information of the input signals.
Pressing DISPLAY displays the type of input digital
signals and the listening mode.
4 5 6
9
7
8