Error Messages; Wear Parts; Spare Parts - Oase Eco Control Notice D'emploi

- EN -

Error messages

Once a malfunction has been remedied, the error message automatically disappears.
Error message
WARNING
NO WATER
WARNING
MOTOR BLOCKED
WARNING
HIGH TEMPERATURE
WARNING
HIGH POWER
Storage/overwintering
The unit is frost-proof to -20 °C. If lower temperatures are expected, the unit must be removed and put into storage.
How to correctly store the unit:
• Protect the EGC plug from moisture and dirt.

Wear parts

The following components are wear parts and are excluded from the warranty:
• EGC plug seal
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system provided for
this purpose.

Spare parts

The use of original parts from OASE ensures continued
safe and reliable operation of the unit.
Please visit our website for spare parts drawings and spare
parts.
14
Cause
The pump has run dry (dry run protection has tripped).
Filter housing clogged (dry run protection has tripped).
Impeller unit is blocked (dry run protection has tripped).
Ambient temperature for dry installation is too high.
Water temperature too high
Current consumption too high
− Impeller unit running sluggishly
− Excessively soiled water
Remedy
− Flood the pump.
− Fully submerge the pump for operation in a pond.
− Vent the supply line.
− Remove any blockage from the supply line.
Clean the pump.
Disconnect the power supply and remove obstacle. Then
switch the pump on again.
− Avoid exposure to direct sunlight.
− Note maximum water temperature of +35°C.
Note maximum water temperature of +35°C.
Clean the pump.
www.oase-livingwater.com/spareparts