Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HET 3111
b. Wall fixing
(see page 72)
•
Locate the point of installation.
Pay attention to where you want to install the appliance and
check that there are no inflammable products nearby (for example
curtains, tapestry etc.). Leave at least 1 metre from them.
•
Remove the bracket (S) from the rear part of the appliance body (1) (figure "A" - page
72).
•
Mark the drilling points and then drill the wall.
•
Insert the wall plugs (T) in the holes (F); fix the bracket (S) to the wall with the screws
(V) (figure "B" - page 72).
☞
Use wall plugs suitable for the type of wall.
•
Correctly hang the appliance making sure the holes located on the rear part of the
appliance body (1) are aligned with the bracket (S) (figure "C" - page 72).
•
Tighten the screws on the upper part of the bracket (figure "D" - page 72).
☞
The appliance cannot be installed in bathrooms or near sinks or
taps.
☞
Make sure the power outlet is near the appliance in order to avoid
using extension cables.
☞
Make sure the appliance is firmly fixed to the wall.
INSTALLATION
EN
71
Publicité
Table des Matières
