Wall Fixing - ohmex HET 8015 WIFI Manuel D'utilisation

HET 8015 WIFI
b. Wall fixing
• Locate the point of installation.
Pay attention to where you want to install the appliance and
check that there are no inflammable products nearby (for example
curtains, tapestry etc.). Leave at least 1 metre from them.
• Remove the bracket (S) from the rear part of the appliance body (1) (figure "A" - page
66).
• Mark the drilling points and then drill the wall.
• Insert the wall plugs (T) in the holes (F); fix the bracket (S) to the wall with the screws
(V) (figure "B" - page 66).
☞
Use wall plugs suitable for the type of wall.
• Correctly hang the appliance making sure the holes located on the rear part of the
appliance body (1) are aligned with the bracket (S) (figure "C - page 66").
• Tighten the screws on the upper part of the bracket (figure "D" - page 66).
☞
The appliance cannot be installed in bathrooms or near sinks or
taps.
☞
Make sure the power outlet is near the appliance in order to avoid
using extension cables.
☞
Make sure the appliance is firmly fixed to the wall.
INSTALLATION
EN
65