Unpacking; Product Identification - Desa RLP30A Manuel D'utilisation

SaFety INFOrMatION
Continued
11. Do not use heater in basement or below
ground level. Propane gas is heavier than
air. If a leak occurs, propane gas will sink
to the lowest possible level.
12. Keep appliance area clear and free from
combustible materials, gasoline, paint
thinner and other flammable vapors and
liquids.
13. Do not use heater in areas with high dust
content. Dust is combustible.
14. Minimum heater clearances from combus-
tibles: Outlet: 6 Ft. (1.83 m), Sides: 2 Ft.
(0.61 m), Top: 6 Ft. (1.83 m), Rear: 2 Ft.
(0.61 m)
15. Keep heater at least six feet from propane
tank(s). Do not point heater at propane
tank(s) within 20 feet.
16. Keep propane tank(s) below 100° F
(37.8° C).
17. Check heater for damage before each
use. Do not use a damaged heater.
18. Check hose before each use of heater.
If highly worn or cut, replace with hose
specified by manufacturer before using
heater.
19. Locate heater on stable and level surface
if heater is hot or operating.
20. Not intended for use on finished floors.
21. Never block air inlet (rear) or air outlet
(front) of heater.
22. Keep heater away from strong drafts,
water spray, rain or dripping water.
23. Do not leave heater unattended.
24. Keep children and animals away from
heater.
25. Never move, handle or service a hot, op-
erating or plugged-in heater. Severe burns
may result. You must wait 15 minutes after
turning heater off.
26. To prevent injury, wear gloves when han-
dling heater.
27. Never attach duct work to front or rear of
heater.
28. Do not alter heater. Keep heater in its
original state.
113855-01D
29. Do not use heater if altered.
30. Turn off propane supply and unplug heater
when not in use.
31. Use only original replacement parts. This
heater must use design-specific parts.
Do not substitute or use generic parts.
Improper replacement parts could cause
serious or fatal injuries.
1. Remove all packing items applied to
heater for shipment. Keep plastic cover
caps (attached to inlet connector and
hose/regulator assembly) for storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If
heater is damaged, promptly inform dealer
where you bought heater.
Hot Air Outlet
(Front)
Ignitor
Button
Automatic
Control Valve
Button
Hose/Regulator
Assembly
Figure 1 - 35,000 Btu/Hr Model Shown
www.desatech.com

uNPaCkINg

PrODuCt
IDeNtIFICatION
Outer Shell
Handle
Motor
Power
Cord
3