Step 5. Optional Rear Filler Kit; Step 6. Plug In And Place - Samsung NX58H9500WS Manuel D'installation

Step 5. optional rear filler kit

Used to fill gap between the range back and wall. Adds a filler strip to
the rear of the range. This kit can only be used when the opening in the
WARNING
countertop is 25" deep.
If the countertop depth is greater than 25", there will be a gap between the
filler kit and the back wall.

Step 6. plug in and place

bEFORE OpERATING OR TESTING, follow the grounding
requirements on pages 23 ~ 24 in this manual. Improper connection
WARNING
of the grounding plug can result in a risk of electric shock.
• All gas ranges come with a power cord. The power cord
is connected to the rear of the range. Please review "Electrical
requirements" on pages 23 ~ 24.
• All U.S. and Canadian models are produced with a 3-wire, 120-volt,
60-Hertz electrical system. The entire system, including the power cord,
is preinstalled and prewired at the factory. Altering any part of this system
may result in a short or overload.
1. Plug in the power cord. Make sure the outlet
meets local or national electrical codes as
referenced on pages 23 ~ 24.
2. Slide the range into place.
3. Check the gas supply line to make sure it did
not get damaged and it stayed connected
during positioning.
4. Check to make sure the back leg of the range has slid into the anti-tip
bracket. Carefully tip the range forward to ensure that the anti-tip bracket
engages the back brace and prevents tip-over.
A-00_EN-140509.indd 31
English - 31
Gas Range Plug
2014-05-11 9:30:43