Samsung NX58H9500WS Manuel D'installation page 21

cAUTION
cAUTION
1. The counter top around the cut-out should be flat and leveled (see hatched
area on Fig. 1).
2. Before installing the unit, measure the heights of the two cabinet sides
(C1~C4), front and back (See Fig. 1) from the floor to the top of the counter.
3. Level the range using the four leveling legs so that the height from the floor
to the underside of the cooktop frame is greater than the tallest cabinet
measurement by at least 1/16".
4. Slide the unit into the cabinet (DO NOT pUSH THE UNIT HARD). Make
sure the center of the unit aligns with the center of the cabinet cut-out.
5. The metal flange under each side of
the cooktop MUST be placed over
the cabinet countertop for proper
unit support. The cooktop should
NOT rest directly on the countertop
or else it could cause damage to
the cooktop voiding the warranty.
Level the unit if needed.
IMpORTANT: MAKE SURE the unit is supported by the leveling legs and NOT by
the cooktop itself.
A-00_EN-140509.indd 21
Do NOT lift or handle the unit by the cooktop frame.
Fig. 1
English - 21
C2
C1
C4
C3
2014-05-11 9:30:35