Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• The weight of the device will be applied to the wall. If the strength of the wall is not suffi-
cient, reinforcement must be done to prevent the transfer of vibration.
• Do not drop or apply unnecessary force to the device when installing. Internal parts may
be damaged and may become highly dangerous.
Be sure to do
• Install the unit on a vertical wall and ensure that it is level.
Item
• When installing with bare hands, take caution to
not inflict injury.
• Be careful not to hit electrical wiring, gas, or water
piping while drilling holes.
1. Drill a single screw hole, making sure to hit a stud.
2. Insert and tighten the screw and hang the unit by
the upper wall mounting bracket.
3. Determine the positions for the remaining four screws
(two for the top bracket and two for the bottom), and
remove the unit.
4. Drill holes for the remaining four screws.
5. Hang the unit again by the first screw, and then
insert and tighten the remaining four screws.
6. Take waterproofing measures so that water does
not enter the building from screws mounting the
device.
• Make sure the unit is installed securely so that it will
not fall or move due to vibrations or earthquakes.
• If this water heater is being installed at an elevation of 610m
(2,000') or higher, disconnect the connector labeled "High
Elevation Disconnect" as illustrated on the right. This con-
nector is located inside the unit.
• Disconnect power to the Water Heater before disconnecting
this connector. Failure to perform this step will result in a
"73" code displayed on the Remote Controller and a cease in
operation. If this occurs, disconnect, then reconnect power
to the Water Heater to reset the system.
8.
Vent Pipe Installation
Vent Terminal Installation
• Follow the installation instructions included with the vent terminal. It is suggested that the appliance be
vented horizontally through a sidewall. If a vertical vent termination is required, it must follow the
requirements of this section (p.42-45).
42
Check
CAUTION
Illustration
Location of Screw Hole
Mounting Bracket
(upper)
Locating Screw Holes
Tapping Screw
(Indoor Installation Only)
Publicité
Table des Matières
