Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remote Controller RC-7650M
Installation Guide
Note
Do not connect power to the water heater before the remote controller has been properly installed.
Recommended installation location of the remote controller is in a bathroom.
Included Parts List
Part Name
Remote Controller
Wall Packing
Phillips Roundhead Wood Screw
Wall Anchor
Do not disassemble the remote controller.
Notes on the Installation Location
• The remote should be installed in an easily
accessible location.
• Avoid installing in a place where water or
steam can come into contact with the
controller.
• Avoid locations where special chemical
agents (e.g., benzene, fatty and oily deter-
gents) are used.
• Avoid outdoor installation, or installation in an
indoor location where it will be exposed to
direct sunlight.
Wall Packing
Quantity
1
1
2
2
Remote Controller
Connection of Remote Controller Cord
White Connector
Y-shaped terminals
(two-core)
* Confirm the connection with the labels at
both ends of the remote controller cord.
• A 8m (26') cord can be purchased
separately (Part # RC-CORD26).
• The remote controller cord can be ex-
tended up to 90m (300') by splicing the cord
and using 18 gauge wire to extend the
cord to the appropriate length.
For Installers:
Read this installation guide
carefully before carrying out
installation.
NORITZ AMERICA CORPORATION
Connecting Wire
Phillips Roundhead
Wood Screw
To Remote controller
To Water heater
Wall Anchor
31
Publicité
Table des Matières
