hajdu Z30ErP Instructions De Montage Et D'utilisation page 19

• Mains network electricity may only be connected to the stor-
age tank through a double-pole switch where the distance
between the open contacts is at least 3 mm. This separation
device must be built in to the fixed power supply network.
• If the mains network connecting cabling is damaged in any
way, in order to rule out danger it may be replaced only by
the manufacturer, service centre technicians or similarly
qualified experts.
• Have the first heating cycle checked by an expert.
• Only a qualified expert may remove the electric cover plate.
Failure to follow this instruction can result in an electric shock
or other hazard.
• In order to guarantee safe operation, it is advised to occa-
sionally (approximately annually) have the correct operation
of the appliance and combined safety valve checked by an
expert. In addition, we recommend that every two months
the safety valve vent button should be turned in the direction
of the arrow in order to vent the valve. By doing this it is pos-
sible to clean the valves from any possible accretions (lime-
scale, sand particles etc.).
SERVICE
For regular servicing of appliances or in the event of a fault, please contact one of our
contracted service agents listed in the service notes. If you are not satisfied with the
repair carried out by the service agent, please contact the HAJDU Hajdúsági Ipari Zrt.
customer service desk.
Customer service contact details.
Tel.: +36 52 582-787
E-mail: vevoszolgalat@hajdurt.hu
ENVIRONMENTAL PROTECTION PRECAUTIONS
Please note that at the end of the lifecycle of the product you have purchased, its
characteristics have the potential to harm the environment, primarily the soil and
groundwater, since it contains components (for example, cables) that mean at the
end of its life it is classified as hazardous waste.
At the end of its lifecycle, please do not place the appliance in general household
waste. It should be deposited with a company engaged in collecting waste electri-
cal appliances or returned to the manufacturer so that through the professional
management and recycling of the waste product, together we can help protect the
environment.
EN
3 1 9