Network Interface - Denon DN-V1700 Mode D'emploi

ENGLISH

17 NETWORK INTERFACE

The DN-V1700 is equipped with 10BASE-T and 100BASE-TX interface for connection to networks.
An FTP server is mounted for file transfer. Access is possible using the FTP client (DOS prompt) function included as standard with
Windows™ 95 and later.
The same operation as serial remote is possible using the FTP "SITE" command.
These operating instructions only include a general description of network control.
For details, consult your store of purchase.
2 Specifications
Protocol:
Mounted protocols: TCP, UDP, IP, ARP, and ICMP (in part)
Connection:
Connector type:
2 Pin layout
2 Main unit settings
Network-related settings (IP address, subnet mask, etc.) are made using the serial interface commands. The default values for the
different settings are shown below.
2 FTP server
Settings related to the FTP server (ID, password, etc.) are made using the serial interface commands. The default values for the
different settings are shown below.
32
TCP/IP
Automatic selection of 10BASE-T/100BASE-TX
RJ-45
Pin no.
1
2
3
4
5
6
7
8
IP address
Gateway address
Subnet mask
Default
Log-in ID user
Password noned
Signal name
TXD + Transmission data (+)
TXD _ Transmission data ( _ )
RXD + Reception data (+)
_
_
RXD _ Reception data ( _ )
_
_
192.168.0.1
0.0.0.0
255.255.255.0
Limitations
4 to 10 letters and numbers.
No distinction between capital and small letters.
Name
_
_
_
_