Parallel Remote Control Terminal - Denon DN-V1700 Mode D'emploi

ENGLISH
• List of other commands
(a: Issuing in stop mode, b: Issuing during file playback, c: Issuing in still and pause modes,
d: Issuing during script playback, e: Issuing as FTP "SITE" command)
Command name
54 Player status confirmation
55 Drive test
56 HDD suspend setting
57 Network communications mode setting
58 Log output
NOTE:
When accessing an FTP server with LAN connections, be sure to disconnect from the FTP server before executing the "FU" and
"RB" serial commands. When these commands are executed, the connection is terminated forcibly, so the LAN controller does
not recognize that the FTP server connection has been terminated, possibly resulting in a control error.

15 PARALLEL REMOTE CONTROL TERMINAL

An external controller can be connected to the DN-V1700 for parallel remote control.
2 Specifications
Connector type: D-sub female 15 pins
Pin layout
Pin
no. Name
*1
q
search 1/6
w
search 2/7
e
search 3/8
r
search 4/9
t
search 5/10
y
select
7 shift
8 play
9 GND
10 stop
!1
9/repeat
!2
8/single
13 AUX1
14 AUX2
15 +5V
*1) Circled numbers: The function of the key changes when the key is pressed while pressing the shift button.
*2) TTL level (pull-up resistor included)
*3) Press and hold in the stop button (for at least 2 seconds) to stop script playback.
*4) Maximum output current at low level: 64 mA.
(NOTE 1): Make sure the power consumption of the external device supplied by this pin is 200 mA or less.
28
Command
Input/ Level
Logic
Output *2
Input Negative TTL
Input Negative TTL
Input Negative TTL
Input Negative TTL
Input Negative TTL
Input Negative TTL
Input Negative TTL
Input Negative TTL
Power
_ _
supply
Input Negative TTL
Input Negative TTL
Input Negative TTL
Output Negative TTL *4
Output Negative TTL *4
Power
_ _
supply
Function
?S Player status confirmation
nTE Check of playback medium speed
nHS HDD suspend setting
nHD Switch between full duplex and half duplex
nLW Output log to file
Description of pin
Modes other than script mode
Normal
Selects 1st file in sorting order
Selects 2nd file in sorting order
Selects 3rd file in sorting order
Selects 4th file in sorting order
Selects 5th file in sorting order
Switches current directory
Press while operating keys q to y, !1 and !2 to switch their function.
Starts playback of the current file
Stops file playback
Skips in the sorting order
Skips in the reverse order
Programmable output 1
Programmable output 2
Outputs +5V for driving an external device (NOTE 1)
a b
C C
C
C
C
C
Shift
Selects 6th file in sorting order
Selects 7th file in sorting order
Selects 8th file in sorting order
Selects 9th file in sorting order
Selects 10th file in sorting order
Switches current directory
Turns the repeat mode on and off
Turns the single mode on and off
c d e
C C C
C
Script
mode
KEY 1
KEY 2
KEY 3
KEY 4
KEY 5
KEY 6
*3
KEY 7
KEY 8