Setting The Internal Clock - Denon DN-V1700 Mode D'emploi

ENGLISH

9 SETTING THE INTERNAL CLOCK

The DN-V1700 is equipped with an internal clock. Set the clock before using the DN-V1700.
The clock can be set either by using the controls on the DN-V1700 or by serial port control. For instructions on serial port control, see the
"14 Serial Remote Control Terminal" section.
2 Setting the date and time using the controls on the DN-V1700
Connect the DN-V1700's video output to an external monitor and turn on the power.
STOP
1
TIME SET MODE
2001/07/30-16:58:05
2
2001/07/30-16:45:28
daylight saving xx
3
4
5
TIME SET OK
6
2 Quick set:
Press the PLAY/PAUSE button after step 1 above to reset the seconds to 0.
2 Daylight savings time:
The DN-V1700's current daylight savings time setting is indicated at "daylight saving
press the SELECT button to make the "daylight saving" line flash, then press the PLAY/PAUSE button. The clock is moved ahead
one hour when the setting is switched from "No" to "Yes", back one hour when the setting is switched from "Yes" to "No".
2 Automatic setting by SNTP:
When the date and time is set by SNTP server when connected to a network, "auto set by SNTP" is displayed at step 2 above. Use
the SELECT button to make "auto set by SNTP" flash, then press the PLAY/PAUSE button. The time can now be set by SNTP.
NOTE:
When the above setting is made, we recommend repeating the operation in step 1 to check the current time.
A super capacitor is used to keep the DN-V1700's internal clock running even when the power is turned off. The clock keeps
running for about 7 days after the power is turned off (as long as the power was on for at least one hour beforehand). If the clock
stops running, the date and time are reset to "2000/1/1 00:00:00".
18
OSD/
TIME SET
In the stop mode, press the OSD/TIME SET button while pressing the STOP
button.
The following appears on the external monitor:
"TIME SET MODE"
"yyyy/mm/dd-hh:mm:ss" (current date/time)
"yyyy/mm/dd-hh:mm:ss" (set date/time)
"daylight saving **" (see note below)
"yyyy" flashes.
SKIP
Use the SKIP button to set the year (A.D.).
SELECT
Press the SELECT button to move to the months' place.
Repeat steps 3 and 4 to set the date and time.
Once the setting is completed, press the OSD/TIME SET button. "TIME SET OK"
is displayed and the setting is completed.
When the key lock mode is set, cancel the mode using the "KL" serial
command.
Press the STOP button to cancel the setting.
" in step 2 above. To change the setting,