W-Dmx™ Status - Cameo OTOS H5 Manuel D'utilisation

W-DMX™ STATUS
W-DMX W-DMX
as receiver
deactivated
activated,
not paired
CONTROL MENU (Control)
The control menu enables selection of the various operating modes and their setting options in
the relevant sub-menus. DMX address and DMX operating mode are set in each operating mode
across all operating modes, if relevant.
DMX OPERATION VIA DMX CABLE
Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to select
the Control menu and press ENTER. Now select the DMX menu item and confirm again.
Information on the sub-menu items in the DMX menu and the corresponding setting options can
be found in the table below.
DMX
DMX Address Setting the DMX start address
Mode Selecting the DMX mode
W-DMX Deactivate sending of the DMX control signal via W-DMX
Transmitter
Activate DMX control signal forwarding via W-DMX
Pairing with ready-to-pair W-DMX devices
Disconnect all W-DMX connections
W-DMX standard Selection of the W-DMX transmission standard
W-DMX W-DMX
as receiver as receiver as receiver
activated activated
and and
paired, paired,
Transmitter no DMX signal
switched off DMX signal is present
or out of
range
W-DMX W-DMX W-DMX
as trans- as trans-
activated mitter
and with G3 with G4s
paired, standard standard
activated, activated,
DMX signal DMX signal
is present is present
W-DMX W-DMX
as trans- as trans-
mitter mitter
with G3 with G4s
standard standard
activated, activated,
no
DMX signal DMX signal
001–486
26CH Standard
32CH Extended
Off
On
Force to pair
Unlink All
G3
G4s
mitter
no
17