2
Product information
2.1
Included items
• Tank
• Tank drain (factory installed)
• Installation and Service Instructions
• Compensating spring for aquastat or tank temperature sensor
• B-KIT
1
Fig. 1 B-kit
[1]
Tee section 1" x 1" x ¾ "
[2]
Temperature and pressure relief valve
[3]
Coupling ¾ "(3x)
[4]
Bracket for aquastat, screws for aquastat bracket (2x)
2.2
Intended use
The tank is designed for heating and storing drinking water. Please
observe national, regional, and local codes, regulations, guidelines and
standards for drinking water.
Install this tank only in sealed unvented hydronic heating systems.
Any other purpose is considered improper use. Any resulting damage is
excluded from the manufacturer's warranty.
Requirements for drinking water Unit
Water hardness, min.
pH value, min. – max.
Conductivity, min. – max.
Tab. 3 Requirements for drinking water
S 32/5 – 6 720 804 007 (2013/02)
3
2
4
6 720 801 773-13.1ITL
ppm
36
grain/US gallon
2.1
°dH
2
6.5 – 9.5
μS/cm
130 – 1500
2
Product information
5