Initial Start-Up; Booting The System - Fujitsu LifeBook V1040 Guide Pratique

Initial Start Up
Wall Jack
LAN Port
Wireless LAN/Bluetooth
on/off Switch
Display Panel
Latch Button
optional modem Jack
Right Side
Power/Suspend/
Resume Button
1. open the Display Panel
• Ensure that your LifeBook is on a hard level surface and that
the air vents are not blocked.
• Press latch button and lift the display, being careful not
to touch the screen.
• Adjust the display until it is at a comfortable viewing angle.
2. Connect AC Power
• Plug the AC adapter into your notebook.
• Plug the power cord into the AC adapter.
• Connect the power cord to an electrical outlet.
3. Connect to Internet or Network
• Connect either a phone cord to the optional modem jack or an
Ethernet cable to the LAN jack on your notebook and to a wall
jack or to an Ethernet router.
Important:
• During the setup procedure, do not disconnect the power supply,
press any buttons, or use any peripheral devices such as a
mouse, keyboard, or remote control.
• You should not attach any external devices and do not put a DVD/CD in
your drive until you have gone through the initial power on sequence.

4. Booting the System

The Lithium ion battery is not charged upon purchase.
Initially you will need to connect either the AC adapter
or the Auto/Airline adapter to use your notebook.
• Press the Power Suspend/Resume/button (above the keyboard) to
turn on the notebook. When you do this for the first time, it will display
a Fujitsu logo on the screen. If you do nothing the system will load
the operating system, and then the Windows Welcome will begin.
5. Register
• Accept the Microsoft Windows
®
Fujitsu End User License Agreement to proceed.
• Select your User ID and Password during the "Welcome Screen."
• Keep a record of your User ID and password stored in a secure place.
• THE SCREEN WILL GO DARK FOR APPROXIMATELY TWO MINUTES.
• Do not attempt to turn power on or off during this stage.
6. Registering Your LifeBook notebook
• Register your notebook with Fujitsu Service and Support via our
website at us.fujitsu.com/computers.
• You will need to be set up with an Internet Service Provider (ISP)
to register online.
7. Installing Click me!
• Check to be sure the WLAN switch is on. In
addition to an icon on the desktop, a dialog
box will automatically open that prompts
you to run Click Me!. If you choose not to
run ClickMe! at this time, the ClickMe! icon
will remain on your desktop.
• When you click the ClickMe! icon, your system will automatically
build the icon tray in the bottom right of the screen. These icons
provide links to utilities that you will frequently access.
• For the latest drivers, please go to http://www.fujitsu.com/us/
support/ and follow the links to the downloads.
Licensing Agreement and the
®
(For
Additional
Utilities)
"Click me!"
2