Listening To The Radio; Cassette Operation; Playing Cds/Mp3 - AEG MC 4409 Mode D'emploi

Listening to the Radio

1. Press the TUNER/BAND button (27/13) to select between
FM or MW.
VHF = FM, Medium wave = MW (mono)
2. Tune in to the desired station with the help of the << SKIP/
TUNING >> buttons (8/3).
3. The FM.ST control lamp (
if the selected station is being received in stereo quality. If
reception is too weak and there is noise on the station being
received, this lamp will fl icker. Try to improve reception by
turning and bending or twisting and altering the length of
the antenna (30). In the case of FM stations you can use
the ID3/FIND/ST./ESP button (11 on the remote control)
to switch between MONO and STEREO reception. Where
reception is bad we recommend switching to MONO.
4. An aerial is integrated into the device for the reception of
AM stations. The machine can be aligned to the station by
turning it. In this frequency band programs are transmitted in
„mono" only.
5. If you have found the desired station, press the MEM/CLK-
ADJ button (10/6). The word PRG lights up and the station
memory number fl ashes.
6. In order to select the program location, press the << ALBUM/
MEM >> buttons (16/4).
7. To store this position, press the MEM/CLK-ADJ button
(10/6). Please note that the programme storage location
must be entered within fi ve seconds as the procedure is
then cancelled.
To select a stored station press the << ALBUM/MEM or
ALBUM/MEM >> button.
Note: By pressing the TUNER/BAND button (27/13) you can
also switch over to radio mode.

Cassette Operation

Playing Cassettes
1. Press the FUNCTION button (6/8) repeatedly until the word
„TAPE" appears in the display.
2. Press the / stop/eject button (21) to open the cassette
compartment (19).
3. Push a recorded audio cassette, with the tape downwards
and the listening side facing forwards, into the compartment
(full reel to the left). Then close the cassette compartment
(19) again.
4. Press the playback key (24) to listen to the tape.
5. With the / stop/eject key you can stop playback.
6. Wind the tape forwards or backwards if necessary in the
direction of the arrow keys
= forwards (22),
7. Always press the /
the direction or stopping the tape. This prevents damage to
the machine and the tape.
8. If the / stop/eject button is pressed again the fl ap of
the cassette compartment opens.
9. In order to interrupt playback briefl y, press the II pause
button (20). Pressing again continues playback.
50
05-MC 4409 CD AEG 50
ST ) (in the display) only lights up
( )
= reverse (23).
stop/eject key (21) when changing
Note: By pressing the TAPE button (17 on the remote control)
you can also switch over to cassette mode.
Recording Cassettes
1. Insert an audiocassette with the side on which you wish
to record facing forwards (full reel on the left). Ensure that
the cassette is not copy-protected (the copy protection tab
on the top narrow side of the cassette must not have been
removed).
2. Select the recording source with the FUNCTION button (6/8)
and then start this source. The sound source which you are
listening to is the one from which the recording is made. The
recording level is controlled automatically. Any changes to
the sound and volume do not affect the recording.
b
3. Please press the record button (25) (the
button is automatically pressed down at the same time).
Recording now begins. All previous recordings are automati-
cally erased.
4. The recording can be interrupted briefl y using the II pause
key (20), or stopped by means of the
button (21).

Playing CDs/MP3

This is how you play a CD
1. Press the FUNCTION button (6/8) repeatedly until „CD"
appears in the display.
2. In order to open the CD compartment (11), press the
(open) button (12).
3. Insert an audio CD with the printed side facing upwards on
to the central cone so that the CD clicks into place and then
close the lid of the CD compartment.
4. AUDIO CDs:
In the display the symbols "Cd" and "ESP" appear together
with the number of tracks and the total playing time. Press
the PLAY/PAUSE button (14/1) to play back the CD. The CD
is played from the fi rst track onwards. The track currently
being played and the time that has elapsed are shown in
the display.
CDs in MP3 Format:
In the display the symbols "STOP" and "ESP" appear toge-
ther with the number of folders e.g. 04 and the total number
of tracks. Press the PLAY/PAUSE key (14/1) to play the
CD. The CD is played back from the fi rst track onwards and
from the fi rst folder. The song currently being played and the
time that has elapsed are shown in the display. With the <<
ALBUM/MEM or ALBUM/MEM >> (16/4) you can select the
individual folders.
5. To remove a CD, press the STOP key (17) (2 on the remote
control), open the CD deck with the
take out the CD carefully.
Always keep the CD deck closed.
Note:
• If a disc is inserted incorrectly or no disc is inserted, the
letters „CD READ", and „NO DISC" appear in the display.
• Playback of CDs produced by the user cannot be guaran-
teed due to the large variety of software and CD media
available.
playback
/ stop/eject
(open) key (12) and
28.07.2006, 11:03:34 Uhr