General Safety Instructions; Special Safety Information; Overview Of The Components; Remote Control - AEG MC 4409 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

General Safety Instructions

Read the operating instructions carefully before putting the appli-
ance into operation and keep the instructions including the warran-
ty, the receipt and, if possible, the box with the internal packing.
To avoid the risk of fi re or an electric shock, you should not
expose the device to rain or moisture. Consequently, do not
use the device in the immediate vicinity of water - for examp-
le near a bath tub, a swimming pool or in a damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug socket.
Pay attention that the specifi ed voltage corresponds to the
voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs can
constitute a considerable risk for the user. Should the device
become damaged, in particular the mains supply cable, do
not operate the device any longer, but rather have it repaired
by an expert. Check the mains supply cable regularly for
damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manufactu-
rer, our customer service department or a similary qualifi ed
person.
If the device is not used for a longer period, remove the plug
connector from the plug socket or take out the batteries.
These symbols may be found on the machine and are intended
to indicate the following:
The lightning symbol should advise the user of parts
in the inside of the device which carry dangerously
high voltage levels.
The symbol with an exclamation mark should advise
the user of important operation or maintenance
instructions in the accompanying documentation.
Devices bearing this symbol work with a „class 1
laser" for tracing the CD. The built-in safety switches
should prevent the user being exposed to dange-
rous laser light, which is invisible to the human eye,
when the CD compartment is opened.
Under no circumstances should these safety switches be
bypassed or manipulated, as this could result in a danger of
exposure to the laser light.
Children
In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
Caution! Do not allow small children to play with the foil as
there is a danger of suffocation!
To protect children from the dangers posed by electrical
appliances, make sure that the cable is hanging low and that
children do not have access to the appliance.
48
05-MC 4409 CD AEG 48

Special safety information

This device works with
a class 1 laser.

Overview of the Components

1 PHONES Headphones connection
2 STANDBY control lamp
3 IR Sensor for the remote control
4 STANDBY/ON button
5 VOL.DOWN/UP (volume) control
6 FUNCTION Function selector button
7 USB connection
8 << SKIP/TUNING >> buttons
(forward search/reverse search)
9 FLASH MEMORY Slot
10 MEM/CLK-ADJ button (memory/time)
11 CD compartment
12
(open) CD compartment
13
LCD display
14 PLAY/PAUSE button (Play/Pause)
15 EQ (Equalizer) button
16 << ALBUM/MEM >> buttons
17 STOP button
18 Flap
19 Cassette compartment
20 II Pause button - cassette
21
/
Stop/Eject button - cassette
22
Forward button - cassette
23
Reverse button - cassette
24
Playback button - cassette
25 b Recording button - cassette
26 FLASH MEMORY/USB control lamp
27 TUNER/BAND button
Reverse Side
28 SPEAKER RIGHT/LEFT Loudspeaker connections
29 Mains connection
30 FM ANT throw-out aerial
31 BEAT CUT 1/2 switch

Remote Control

1 PLAY/PAUSE button (Play/Pause)
2 STOP button
3 << SKIP/TUNING >> buttons
(reverse search/forward search)
4 << ALBUM/MEM >> buttons (down/up album)
5 REPEAT button (repeat)
6 MEMORY/CLK-ADJ button
7 RANDOM button (random)
8 FUN C TION Function selector button
9 MUTE button
10 VOL (volume) buttons
11 ID3/FIND/ST./ESP button
12 STANDBY/ON button
13 TUNER/BAND button
14 SLEEP button
15 TIMER button
16 EQ button
17 TAPE button
28.07.2006, 11:03:29 Uhr

Publicité

Table des Matières
loading

Table des Matières