Declaration Of Conformity; Card Programming - Leb electronics CTR58 Manuel D'emploi

ENGLISH
G) DECLARATION OF CONFORMITY
Equipment description: Electronic board affected to the control of a motor working at 24Vdc intended for the automation of a sliding gate.
Model: CTR58
Applied rules: EN 61000-6-3, EN 61000-6-1, EN 301489-1, EN 301489-3, EN 300220-2, EN 300220-1, EN 60950-1
Test laboratory : NEMKO SPA
Result: Positive
The manufacturer declares that above mentioned products comply with rules required by European directives 2004/108/EC and 2006/95/EC.
Date: 22-06-2017
H) Card programming
Learning of remote control codes
Press the key P1 once to enter a Start code. Press the key P1 twice to enter a Pedestrian Start code. Each pressure of the key P1 causes a blinking of
the Led DL1 on the card. After having made the selection, the Led DL1 will switch on with fixed light. Then press the key on the remote control to be
memorized, the DL1 will switch off signalling that the code has been memorized. In case of lacking recognition of the code the Led DL1 stays lighted for
10 sec., afterwards it will automatically switch off (operation end). Repeat the above mentioned operation for each remote control code to be
entered.
Cancellation of a memorized code
Press the key P2. At key release the Led DL1 will switch on with fixed light. Press the key to be cancelled on the remote control and check the Led
DL1 switches off. In case of lacking recognition of the code the Led DL1 stays lighted for 10 sec., afterwards it will automatically switch off.
Cancellation of all memorized codes
To cancel all remote control codes in the memory (total emptying), keep the key P2 pressed for 10 sec. until the switching on for 1 sec. of the Led DL1.
"Far Storing" - Alternative procedure of code entry (only by Rolling Code remote controls)
The receiver on the card is prearranged for remote self-learning of SMARTY (programmed in Rolling Code) and ROLLY if it has got at least
one already memorized remote control code. The procedure to be followed is this one:
a) Press on the new remote control to be entered the wished key for at least 6 seconds, until the switching on of the Led DL1.
b) Press on the already previously memorized remote control the operation key. The Led DL1 on the card will switch off while the blinker will switch on
with fixed light (until the key is pressed) signalling that the new remote control has been memorized. In case of lacking recognition of the code the
Led DL1 stays lighted for 5 sec., afterwards it will automatically switch off (operation end).
WARNING: The receiver on the card comes from factory without any pre-set working modality (Fixed Code, Rolling Code or Secret key). The
first remote control entered will determine the working modality and, once established, it will be no more possible to modify it. The sole way
to bring back the card to original conditions is to program it again by Leb's premises.
19