Fireplace Surface Cleaning - Ruby Fires MF1620C Mode D'emploi

II. Operation of Remote Controller and Control Panel
This fireplace includes a remote controller. Please ensure the remote
controller is used with batteries included. The remote controller will
not work when it is without batteries or batteries out of power. Please
direct the remote controller at the electric fireplace at 1-5 meters
distance, otherwise the remote controller could not work properly.
Please point the remote controller to the relevant grid for the required
functions. Do not cover the receiver on the remote controller.
There is one main power switch on the appliance and four buttons on
both control panel and remote controller of the fireplace.
When the cassette version is built in, there is a possibility that you
have to hold the remote higher for a good connection with the
receiver.
A. POWER SWITCH: This is a switch for main power of the electric
fireplace, turn the switch to I for power on. Once power is turned on,
it comes with a crisp warning tone to warn the operator the power
supply has been connected. All the function operations will not start automatically. To turn off the
power, turn the switch to O.
Remote Control:
B. ON/OFF: Push the ON/OFF button once to turn on the internal electric source of fireplace.
Meanwhile, the indicator light is on and simulated log set is lit up. Please note it will take about 48
seconds to see the flame effect due to the mist generation process. The heater functions will not
turn on unless push the heating buttons. Push the ON/OFF button again to turn off the fireplace.
C. DIMMER+ and DIMMER-: Flame adjustment, dimmer+ for higher flame effect and dimmer- for
lower flame effect. This unit has the memory function, it keeps the record for last flame adjustment
when you use it next time. If you don't see the flame after 48 seconds, please try to push dimmer+,
a few times.
D. LOW/HIGH: When the unit is under working condition, push the LOW button once, the heater
starts to work at low heating after a warning tone. Push the button again, the heater stops. Push
the HIGH button once, the heater starts to work at high heating after a warning tone. Push the
button again, the heater stops. When the unit is under low heating, push HIGH button will switch
from low heating to high heating.
E. Switch off the power if you leave the fireplace for a long time.
If the cassette version is built in and you find that the remote control is not responding properly,
you can twist the adjustable feet slightly up, so that the recipient is better in sight.

Fireplace Surface Cleaning

Use a cloth dampened with warm water only to clean painted surface of electric fireplace. Do not
use abrasive cleaners.
Service
Except bulb replacement, water refill, atomizer cleaning and surface cleaning, all the other clean-
ings or modification please contact its service agent.
caution riSk of electric Shock. Do not oPen the
firePlace.
9