Refilling Water - Ruby Fires MF1620C Mode D'emploi

4. If there is no satisfactory socket near the selected position, please ask a professional electrician
to install the socket behind or near the frame as per requirement.
WarninG
Do not install an electric circuit or socket arbitrarily in order to prevent fire accidents, elec-
tric shock or physical injury. Please ask a professional electrician to install the circuit.
1. Turn off the switch on the core of the fireplace.
2. Insert the power plug into AC230V/15A socket. The cable should be laid along the wall.
3. Pull the core of fireplace into the frame or the wall structure until it parallels with the panel or
wall.
4. Finish the installation ensuring that the power plug is accessible after installation.
5. Level the fire by adjusting the feet.
note
If necessary, the profiles on the side of the unit can be easily removed by removing the two
screws.

reFillinG Water

1. When there is no mist, or you hear the water shortage alarm, please refill the water tank imme-
diately.
2. When the water no longer covers the atomization sheet, atomization stops in 3 seconds and
there will be no flame effect.
3. When the atomizer stops, please turn all controls off, unplug the appliance, refill the water tank,
plug back in and restart.
4. fill Water tank with tap water only. Distilled water must not be used.
A. Remove the log set. Please note that the log
set is first tipped forward and then lift and remove.
When replacing vice versa, thus placing first front
and then backwards.
B. Take out the water tank.
C. Twist off the cap on water tank for water refilling.
Before placing it back, carefully check that the wa-
tertank is not leaking. Close the cap tightly.
5