Batteries Replacement - Tanita KP-601 Mode D'emploi

11
Press ON/OFF to
turn off.
* When the registered weight is insufficient, "PC-25" is displayed. In that case, increase the
number of specimens to 25 pieces. When the stable mark is displayed, press CAL. If the register
is still insufficient, the display changes to show the number of specimens to be increased.
Therefore, increase the number of specimens, and press CAL again. This operation is repeated
until the registered weight becomes 1 g or more.
the registered weight is too low to measure. Numeric numbers change as follows. (Press TARE
to increase the number of specimens)
10 → 25 → 50 → 100 → 150 → 200 → 250 → 500
PROGRAMMING AUTO POWER OFF
Default setting is 10 minutes
◆
The auto power off time can be programmed between 0 (= no auto power off) to 60 minutes by
◆
10 minutes increments according to preference.
1 2
When the power While pressing
is off MODE press
ON/OFF.
5 6
0
60 10
50 20
40 30
The numeric values Press TARE to cycle
are displayed. through the time
options.
* If the power turns off before appears, the setting is not saved.
6
will be displayed when you press CAL if
3 4
Press CAL to display Press MODE to
confirm
.
7 8
Wen you have made Setting is finished.
your selection, press
MODE to confirm.
PROGRAMMING BACKLIT BRIGHTNESS
Default setting is "2".
◆
1 2
When the power While pressing
is off MODE press
ON/OFF.
5 6
0
4 1
3 2
The numeric values Press the TARE to
are displayed. cycle through the
backlit options.

BATTERIES REPLACEMENT

When batteries are running low, is displayed. When batteries are running out,
displayed and the power is automatically turned off.
Immediately replace with new batteries (all 4 batteries). Do not apply excessive force to the
measuring section when replacing batteries.
TROUBLE SHOOTING
• The power doesn't turn on.
Insert new 4 size AA (LR6) batteries. Be sure that the polarity of the batteries is set properly.
• appears on the display.
or
The scale needs to be repaired. Please contact your retailer.
3 4
Press CAL to display Press MODE to
confirm.
.
7 8
Wen you have made Setting is finished.
your selection, press
MODE to confirm.
is
7