Tare Function; Automatic Power Off; Changing The Batteries - Tanita AP-101 Mode D'emploi

Instruction For Use
For accurate measurement, place the unit on as flat a surface as possible and
adjust the level with the adjustable feet so the bubble in the level gauge is in
the center of the frame.
03
Level gauge
Adjust the level by rotating
the adjustable feet.
Push [ON/TARE] button.
Note: When you use a container (Gem cup etc.), please
use after turning on a power supply, putting a
container on the weighing tray and carrying out the

tare function.

Approximately 2 seconds later, weighing can
be performed.
Place the object to be weighed.
The display will indicate the weight of the object.
Push [OFF] button to turn off.
Tare Function
Push [ON/TARE] button.
Place a container.
Push [ON/TARE] button to subtract the weight
of the container.
Note: [ON/TARE] button operates only when the stability
mark is on.
Place the material to be weighed, only the
weight of the object will be displayed. The
total weight can be calculated by adding the
weight of the container to the weight of the
object.

Automatic Power Off

If the same reading is displayed for more than 2 minutes the scale will
automatically turn off.

Changing the Batteries

If the display indicates " LO ", press the [OFF] button and change both
batteries at same time.
Remove the battery cover and insert
2 lithium batteries (CR2032)
as shown in Fig.1.
Replace the battery cover.
(Fig.1)
04