Tanita AP-101 Mode D'emploi page 5

Federal Communications
Commission and Canadian
ICES Notice
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules and
Canadian ICES-003. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and
receiver.
●Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
●Consult the dealer or an experienced radio or television
technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications
made to this device that are not expressly approved by Tanita Corporation
may void the user's authority to operate the equipment.
05
Specifications
Model
Measurement System
Weight
Measurement
Capacity/Graduation
Class
Output Item Display
Display
Size
Product
Display
Power source
Temperature range of usage
Weight of equipment
Rated power
This device features radio interference
suppression in compilance with valid EC
Regulation 89/336/EEC.
AP-101
Strain gauge Load cell
120g / 0.1g
Ⅲ
120g / 0.1g increments
29mm×13mm (1.14×0.51in)
160mm×80mm×24mm (6.30×3.15×0.94in)
4Digits LCD
Height of numerals 10mm (0.39in)
lithium battery
+ 5 / + 35
（41° F/95° F）
℃ ℃
160g (5.644oz) [included battery]
DC6.0V [2×CR2032 included]
06