General Information - Atlas Copco RRC13 Manuel D'instructions

Safety and operating instructions
Warning
Make sure you are familiar with the operating instructions before you use this
machine.
This machine, its attachments and accessories must only be used for the pur-
pose for which they were designed:
• General chipping and scaling work, fettling of castings in foundries, hole
making and light demolition in construction and building industry (not for
nailing without proper attachments).
RRC 13N – for removing welding slag, rust and paint from steel structures.
For product liability and safety reasons any modification to the machine, its at-
tachments or accessories must be agreed in advance with an authorized techni-
cal representative of the manufacturer.
RRC 13B
• When operating the tool to blow the workpiece clean – direct tool exhaust
from operator and co-workers.

General information

EC DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB, S-105 23 STOCKHOLM, SWE-
DEN declare that the product (with name, type and serial number, see front
page) is in conformity with the following Directive(s):
2006/42/EC
Harmonised standards applied:
ISO 11148-4
Technical file available from:
Quality Manager, Atlas Copco Industrial Technique, Stockholm, Sweden
Stockholm, 1 July 2013
Tobias Hahn, Managing Director
Signature of issuer
Installation
Installation
RRC 13
• Install chisel (h), see figure.
6
EN
© Atlas Copco Industrial Technique AB - 9836 978500 00
RRC13