Air Intake Connection; Smoke Outlet Connection; Installation, Commissioning And Use Of The Stove; Premise - CASATELLI WENDY Manuel D'installation Et D'entretien

5.4

AIR INTAKE CONNECTION

It is necessary to provide an external air intake to
ensure the flow of combustion air to the stove
The dimensions of the hole must comply with the values
set forth in the table of technical data shown in the manual.
• Is forbidden the intake of air for combustion from garages,
rooms where flammable materials are stored or where
there is danger of fire.
• The combustion air intake should be protected by an anti-
insect grille and placed where it can not be accidentally
obstructed, and made in such a way that the useful
cross-section allows the right amount of oxygen to reach
the stove.
In the room where the stove is located, if there are one
or more extraction fans (exhaust hoods and the like),
there may be problems with combustion due to lack of
combustion air.
5.5

SMOKE OUTLET CONNECTION

Dimensioning the flue must be executed in accordance
with EN 13384-1.
• The SMOKE connection between the stove and flue
should have the same cross section as the stove's smoke
outlet. The smoke fitting must be sealed and the use of
flexible metallic pipes is prohibited.
• In order to connect the stove to the chimney you may
perform maximum 3 changes of direction that should not
exceed 90°, the fume duct should not exceed 2 metres
in length and 3 metres in total (fig.5.2).
• Smoke exit: the first vertical section has at least 50 cm
before changing the direction.
• Follow the indications in the technical data sheet regarding
the chimney draught value.
• The appliance cannot be used in a shared flue.
6 INSTALLATION, COMMISSIONING
AND USE OF THE STOVE
6.1

PREMISE

It is recommended to perform all control and charge using
the utmost caution and making use of the glove supplied.
Remember that YOUR STOVE is not an incinerator.
6.2 REPLACEMENT OF THE HANDLE SHIPPING.
After removing the packing from the stove, replace the
shipping handle with the operating handle.
The components are as shown in Fig. 5.3 -
1) Bolt M6x16
2) Spacer bush
3) Elastic washer
4) Aesthetic handle
5) Handle of transport
A) Unscrew the bolt (1), remove spacer (2) and washer
(3); Remove the transport handle (5) from the door
slit.
B) Insert the operating handle (4) into the door slot and
fit the bush (2) with the washer (3) and the bolt (1)
C) Tighten the bolt (1) through the side hole in the door.
26
26
(-5.1-).
00 477 6240 - 09/2017 - PN - Italy
fig. 5.1
X
fig. 5.2
fig. 5.3
LIBRETTO PRODOTTO - cod. 004776860 - 13/03/2019
X ≤ 2 m
Y ≥ 0,5 m
X + Y ≤ 3 m
Y