Levelling The Stove; Connection To Systems; Fuel Optimisation; Maintenance - CASATELLI LEONARDO 8ET Généralités - Avertissements - Installation - Entretien

5.6 LEVELLING THE STOVE

The stove must be levelled using a spirit level and
by adjusting the feet (where included) (Fig. 5.10).
A B = Spirit Level

5.7 CONNECTION TO SYSTEMS

5.7.1 Electrical connection
Just connect the stove to the electrical system using
the plug provided.
The electrical connection (plug) must be easily
accessible even after installing the stove.
The power cable must not be come into
direct contact with the hot parts of the device.
If the power cable is damaged, it must be replaced
by the technical assistance service or by a qualified
technician in order to prevent any risk.
5.7.1.1 Earthing
The system must be earthed and be fitted with a
circuit breaker in accordance with the laws in force
(Fig. 5.11).
The exhaust fume duct must have its own earth
connection.

5.8 FUEL OPTIMISATION

Excellent fuel depends on different factors
(type of installation, operating and maintenance
conditions, type of pellets, etc.)
When first switched on, the stove combustion can
be optimised.
Generally speaking, if at the end of combustion,
there is a lot of residue in the burn pot, you
should change the combustion configuration
(by increasing the value) until you find the best
solution.
Refer to paragraph 10.3.5 "Fuel optimisation".
6

MAINTENANCE

(To be performed by a qualified technical support
centre)
6.1 MAINTENANCE
Maintenance operations must be performed by an
authorised technical assistance centre.
Before performing any maintenance operation,
take the following precautions:
- Make sure that all the parts of the stove are
cold.
- Make sure that the ashes are completely
extinguished.
- Use personal protective equipment provided
for by Directive 89/391/EEC.
- Make sure that the general line switch is turned
off.
- Make sure that the power supply cannot be
36
accidentally reactivated. Remove the plug from
the wall socket.
- Always use appropriate equipment for
maintenance.
- Once the maintenance or the repair operations
are completed, before re-commissioning the
stove, install again all the protections and
restart all the safety devices.
004778330 - 16/07/2020
Fig. 5.10
Fig. 5.11