Axis A1001 Guide D'installation page 35

Cable connection example
1
6-pin plug connector
2
Network cable
3
Cable tie (4x)
4
Network connector
Note
• For devices that have been configured in the product's hardware configuration pages, use
the hardware pin chart as a guide on how to connect the pins. For more information
about hardware configuration and the hardware pin chart, see Configure the hardware on
page 42.
• For information about how to connect other wires, such as power wires to locks, readers
and other devices, see the manufacturers' instructions.
5. Collect all the wires neatly and secure them using the supplied cable ties.
6. Label the cables for future reference.
7. If using Power over Ethernet, connect the network cable to the network.
8. If using Ethernet and external power (10–30 V DC), connect the network cable to the
network and connect power. Use a SELV compliant limited power source (LPS). For more
information, see Power Connector on page 25.
AXIS A1001 Network Door Controller
35
EN