Network Connector (Poe); Power Lock Connector (Lock) - Axis A1001 Guide D'installation

AXIS A1001 Network Door Controller
Function Pin
1
0 V DC (-)
2
DC input
Network Connector
RJ45 Ethernet connector. Use Category 5e cables or higher.
Function
Power and Ethernet
Power lock connector
4-pin terminal block for powering one or two locks (DC output). The lock connector can also
be used to power external devices.
Connect locks and loads to the pins according to the hardware pin chart generated through the
hardware configuration.
Function Pin
1, 3
0 V DC (-)
2, 4
0 V DC,
floating, or
12 V DC
Notes
For powering controller when not using
Power over Ethernet.
Note: This pin can only be used as
power in.
Specifications
Power over Ethernet IEEE 802.3af/802.3at Type 1 Class 3,
44–57 V DC
Max load on outputs = 7.5 W
Notes
For controlling up to two 12 V locks. Use
the hardware pin chart. See Configure
the hardware on page 42.
26
Specifications
0 V DC
10–30 V DC, max 26 W
Max load on outputs =
14 W
Specifications
0 V DC
12 V DC
Max total load = 500 mA