Safety Instructions - Axis A1001 Guide D'installation

AXIS A1001 Network Door Controller

Safety instructions

WARNING
The Axis product shall be installed by a trained professional, and in compliance with local
laws and regulations.
NO NO TICE NO TICE TICE
• The Axis product shall be used in compliance with local laws and regulations.
• Axis recommends using a shielded network cable (STP) CAT5 or higher.
• To use the Axis product outdoors, or in similar environments, it shall be installed in an
approved outdoor housing.
• Store the Axis product in a dry and ventilated environment.
• Avoid exposing the Axis product to shocks or heavy pressure.
• Do not install the product on unstable poles, brackets, surfaces or walls.
• Use only applicable tools when installing the Axis product. Using excessive force with
power tools could cause damage to the product.
• Do not use chemicals, caustic agents, or aerosol cleaners.
• Use a clean cloth dampened with pure water for cleaning.
• Use only accessories that comply with the technical specification of your product. These
can be provided by Axis or a third party. Axis recommends using Axis power source
equipment compatible with your product.
• Use only spare parts provided by or recommended by Axis.
• Do not attempt to repair the product yourself. Contact Axis support or your Axis reseller
for service matters.
• The power supply shall be plugged in to a socket outlet installed near the product and
shall be easily accessible.
• Use a limited power source (LPS) with either a rated output power limited to ≤100 W or a
rated output current limited to ≤5 A.
Transportation
NO TICE TICE
NO NO TICE
• When transporting the Axis product, use the original packaging or equivalent to prevent
damage to the product.
Battery
The Axis product uses a 3.0 V CR2032 lithium battery as the power supply for its internal real-time
clock (RTC). Under normal conditions this battery will last for a minimum of five years.
10