Nilfisk MC 3C Mode D'emploi page 9

Quick reference guide
This high pressure washer has been designed for
professional use typically in following cleaning ap-
plications:
floor/wall, auto/truck, buildings/constructions, con-
tainer/barrel and craftsman use.
The pictorial quick reference guide
The pictorial quick reference guide is designed for
helping you when starting up, operating and storing
the unit. The guide is subdivided into 5 sections.
A
Before starting
DO READ SAFETY INSTRUCTIONS BEFORE USE!
Operating elements:
1. Inlet water connection
2. Nipple for high pressure hose
3. Lifting handle
4. Cabinet
5. Cable release
6. Oil sight
7. On/off switch
8. Handle hose reel*)
9. Hose reel *)
10. Lock hose reel*)
11. Lance
12. Holder for lance
13. Ergo 2000 spray handle
14. Child lock
15. Holder for spray lance*)
16. Holder with a 2½ l canister *)
17. Cabinet lock
18. Foam Sprayer *)
19. Flexo Power lance*)
20. Placement for lances
21. 4-in-1 lance*)
22. Cable end fixation
23. Foot kick
24. Holder for Foam Sprayer/Canister lid*)
25. Hose hook *)
Assembling the unit:
1.0 Mount handle on hose reel
1.1 Mount filter and Gardena coupling
1.2 Mount the seal and 3/8" nipple on high
pressure outlet
1.3 Connect hoses (water and high pressure
hose)
1.4 Mount the lance
1.5 Connect the electrical cable to mains.
B
Switching on the unit
1.0 Check oil level (see E1.2)
1.1 Open water tap
1.2 Switch on the High Pressure Washer
1.3 Open child lock at spray handle
1.4 Activate spray handle
Optional accessories / Option depending on model
*)
Original instruction
C
Control/operation
Using cleaning agents:
1.0 Check / clean hole in suction limiter at Foam
Sprayer
1.1 Mount Foam Sprayer at canister
1.2 Set spray angle horizontal/vertical
1.3 Activate spray handle.
Nozzle selection at 4-in-1 lance (XT models):
2.0 Turn nozzle head and choose nozzle
Adjust pressure at FlexoPower lance (Standard
models):
3.0 Turn the blue part of the nozzle head Min./
max.
Cable unwind and storage:
4.0 Turn the cable hook for cable release /
storage
4.1 Fixate cable end at hose hook after use
Hose reel unwind:
5.0 Release hose reel lock, and pull out hose
5.1 During use, cable and hose MUST be
completely unwound
D
After using the unit
1.0 Switch off the High Pressure Washer
1.1 Disconnect from mains
1.2 Turn off the water
1.3 Release pressure at spray handle
1.4 Set child lock
1.5 Rewind hose & lock hose reel
1.6 Place spray handle and lance in holders
E
Maintenance
1.0 Unlock cabinet opening cabin locks (use
coin or screwdriver)
1.1 Remove cabinet
1.2 Check / top up with oil to max (SAE 80W-90)
1.3 Oil max v.s. pump type MC 3C (NA3) or MC
4M (NA4)
9