Extel WEVPSF 659 Guide D'installation Et D'utilisation page 64

Installing the control box board
The box must be installed firts, Follow the instructions below :
cable (for connecting the roadside panel) must first be routed through a hole that goes from one side of the
post to the other. The connection (F) must to connect the other two wires to the lock or electric strike plate and on
the connection «LOCK» of control box (fig.4').
-
rence and obstacles between the box and your home, (in particular, no leaves or branches should touch it). For
best results, it should also be placed high enough (approx. 1.6 m above ground level) and be vertical.
N.B. : If the transmission is of insufficient quality, use the 2 m cable supplied to find a better position for the
antenna.
Once you have found the ideal location :
Remove the cover from the box by unscrewing the 6 cross-head screws (H) (fig. 5).
Warning : do not directly touch the electronic circuitry (see comment chapiter safety instruction : Important -
p 3)
N.B. :
Do not install an antenna other than the original one supplied
Warning :
Never insert the batteries before installation is completely finished.
fig.4 fig.4'
H
F
LOCK
+ -
fig.6
fig.5
J
I
H
J
CFI EXTEL WEVPSF 659 - 06/2010 - V1
8GB