Enable The Illuminator Kit - Axis Q8685-EPTZ Mode D'emploi

1
Connector from the illuminator (x2)
2
Connector from the positioning unit (x2)
6. Connect the cables. See Connectors on page 49.
7. Attach the illuminator bracket to the positioning unit using the four screws (T20, torque
3.0 Nm).

Enable the illuminator kit

Note
This is only applicable if you have installed the illuminator kit.
Important
These instructions apply only to device firmware earlier than v8.40.
1. Go to the product's web page.
AXIS Q8685-E PTZ Network Camera
45
EN