Table des Matières
Publicité
Optional installation steps
Install an SD card (optional)
A standard or high capacity SD card (not included) can be used to store recordings locally in the
product. See Specifications on page 49 before installing the SD card.
1. Disconnect power from the product.
2. Remove the four top cover screws and remove the top cover.
3. Insert an SD card into the SD card slot, see Hardware overview on page 18 .
4. Replace the top cover and tighten the screws (torque 3.0 Nm).
5. Re-connect power to the product.
Inverted installation
Note
Follow this installation to set the camera housing in an inverted configuration, if tilting
directly upwards is preferred.
CAUTION
This installation requires two persons.
AXIS Q8685-E PTZ Network Camera
31
EN
Publicité
Table des Matières
