Proper Use; Technical Data - Ergo tools Pattfield E-HKS 1600-Laser Mode D'emploi

Anleitung_E_HKS_1600_Laser_SPK7:_

3. Proper use

The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Voltage 220-240 V ~ 50 Hz
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade 190 mm dia.
Saw blade mount 20 mm dia.
Saw blade thickness
Double isolation
Weight
Laser class
Laser wave length
Laser output
Laser power supply: 2 x 1.5V (AAA)
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 97,1 dB(A)
pA
K uncertainty
pA
L sound power level 108,1 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
30.06.2009 13:01 Uhr
Total vibration values determined in accordance with
EN 60745.
Vibration emission value a ≤ 2,5 m/s
h
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
1500 W
5. Before starting the equipment
4500 rpm
66 mm
Before you connect the equipment to the mains
44 mm
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
2.8 mm
II /
5.1 Setting the cutting depth (Figure 2)
4.7 kg
Release the locking screw on the rear of the guard
hood for adjusting the cutting depth (4).
2
Place the saw foot (6) flat on the surface of the
650 nm
workpiece you wish to saw. Raise the saw until the
≤ 1 mW
saw blade is at the required cutting depth.
Refasten the locking screw for adjusting the
cutting depth (4). Check the handle is securely
fastened.
5.2 Miter stop (Figure 2/3)
The preset standard angle between the saw foot
(6) and saw blade (12) is 90°. You can adjust this
angle to carry out angled cuts.
Release the locking lever for miter setting (7) on
the front of the saw foot.
3 dB
You can now adjust the cutting angle to around
45°. Keep an eye on the cutting angle scale (9) as
you do so.
3 dB
Refasten the locking lever for miter setting (7).
Check the handle is securely fastened.
Seite 13
GB
2
13