Radiant CLOUDWARM Manuel D'installation Et D'utilisation page 77

· Flashing = communication with Open Therm
failure;
· on = heating is on;
· Off = heating is off;
13. Burner flame on.
14. OFF mode enabled.
PARAMETERS REPROGRAMMING
To access the parameters menu press SET once
and while on DISPLAY appears the time, turn the
dual to scroll through the parameters list.
To change the parameter displayed press SET once
and change the value using the dial, confirm by
pressing SET again.
To exit the parameters menu scroll with the dial
through the parameters list until the message
"EhiT" is displayed and confirm by pressing SET.
PARAMETERS LIST
PARAMETER DESCRIPTION
SELECTION OF HYSTERESIS VALUE DURING
SWITCHING ON
INCREMENT BY 0.1°C AT A TIME; DEFAULT
VALUE 0.4°C). FOR EXAMPLE WHEN THE
TEMPERATURE SET BY THE USER IS OF 25°C,
THE HYSTERESIS TEMPERATURE IS OF 0.5°C,
THE ROOM TEMPERATURE IS OF 24.5°C, THE
TRANSMITTER SENDS A HEATING REQUEST
SIGNAL TO THE BOILER.
TEMPERATURE SETTING.
(RANGE FROM 0-2°C;
It may be needed to set the room temperature when
the value differs from the value actually measured
with another precision thermometer.
To access the temperature setting menu hold down
the keys SET and MODE simultaneously. Turn the
dial to change the temperature.
When on display appears "NO", the setting cannot
be made. Wait for about 50 minutes after switch-
on, when the temperature icon "°c" turns from
lowercase to uppercase "°C", and make the setting.
2. USE
PARAMETER DESCRIPTION
SELECTION OF HYSTERESIS VALUE DURING
SWITCHING OFF
INCREMENT BY 0.1°C AT A TIME; DEFAULT
VALUE 0.4°C). FOR EXAMPLE WHEN THE
TEMPERATURE SET BY THE USER IS OF 25°C,
THE HYSTERESIS TEMPERATURE IS OF 0.5°C,
THE ROOM TEMPERATURE IS OF 25.5°C, THE
TRANSMITTER SENDS A SWITCH OFF HEATING
REQUEST SIGNAL TO THE BOILER.
TIME SETTING.
SETTING THE WEEK DAY (FOR EXAMPOLE
"D 1" CORRESPONDS TO MONDAY, "D 2"
CORRESPONDS TO TUESDAY, ETC.)
VERSION OF THE BUILT-IN HARDWARE.
CLOUDWARM WIRED - RAD - ING - Manual - 1606.1
(RANGE FROM 0-2°C;
17