Transmitter - Radiant CLOUDWARM Manuel D'installation Et D'utilisation

2.1.5. TRANSMITTER

The transmitter unit enables data exchange
between the boiler (via the receiver unit) and
your electronic device (Tablet and Smartphone)
managed by the App.
The transmitter is equipped with a sensor that
measures the room temperature displayed by the
App.
When the Wi-Fi network is not available, the
transmitter keeps on working based on the settings
made previously.
The transmitter allows the User to set, in MANUAL
mode, the desired room temperature using the
adjustment dial.
USER INTERFACE (SEE FIG.1)
fig. 1
7
KEY
1. MODE: press to select the manual mode, the
heating programme mode or the Off mode.
2. SET: press to display the time. Hold the key for
5 seconds to start the Wi-Fi association. Press
quickly 2 times to start the setup of the Wi-Fi
via WPS.
16
CLOUDWARM WIRED - RAD - ING - Manual - 1606.1
2. USE
1
2
3
4
5
6
3. Dial: turn it to change the temperature, valid
only in manual mode.
4. Micro USB port for power supply.
5. Reset button: hold the key with a needle to
reset the device.
6. Room temperature sensor.
7. Display.
DISPLAY ICONS (SEE FIG.2)
fig. 2
8
9
10
KEY
8. State of the Wi-Fi connection:
· Flashing = Connection to server in progress
· On = Connection established;
· Off = Connection to the router failed.
9. Manual mode enabled.
10. Heating programme mode enabled.
11. Room temperature.
12. Heating state:
11
12
13
14