Rf Association; Wi-Fi Association - Radiant CLOUDWARM Manuel D'installation Et D'utilisation

2.1.3. RF ASSOCIATION

To associate the receiver and the transmitter in
order to communicate via RF (the default channel is
10; 0-9 are optional channels) proceed as follows:
› Press and hold the key on the receiver (see 1-
fig.1 in "WIRELESS RECEIVER" chapter) until
the fixed green light turns on and the red light
flashes regularly, indicating the activation of the
wireless communication.
› Press the key "MODE" on the transmitter; the
message "rF" - shows that that the wireless
communication is active. When the icon '
the transmitter changes from flashing to fixed, it
shows that the association has been established.

2.1.4. WI-FI ASSOCIATION

To associate the transmitter with a Wi-Fi network
you have two options:
VIA WPS
Press the WPS button first and then press the 'SET'
button of the transmitter twice. If the WPS button is
not available on the router, use the second option.
VIA APP RADIANT CLOUDWARM
1. Connect the mobile device to the Wi-Fi network
(for the initial association the device must be
connected to the Wi-Fi network, and then you
can use a 3G or 4G network to manage the
App).
2. Open the App and sign in.
3. Press on the dots (see fig. 1) on top right of the
interface of the App (in some Android devices
the dot icon may not appear; in this case, press
the button to the left of the HOME symbol of
the virtual menu);
2. USE
' on
4. Press 'Configure Wi-Fi' (see fig.1) and enter
the Wi-Fi Password. DO NOT PRESS "Connect"
YET, FIRST YOU MUST PROCEED WITH THE
NEXT STEP.
5. Press and hold the button 'SET' on the
transmitter until the icon
6. Press "Connect" on App, after 10-20 seconds
the icon
that the connection was established.
If the connection fails:
7. Check if the Wi-Fi connection on your mobile
device is working.
8. Check the router, restart the mobile device and
follow the instructions above,
CLOUDWARM WIRELESS - RAD - ING - Manual- 1606.1
fig. 1
starts flashing;
turns on, steadily lit, indicating
11