Installation Transmitter - Radiant CLOUDWARM Manuel D'installation Et D'utilisation

1.1.4. INSTALLATION TRANSMITTER

WARNING
To ensure proper installation you must
prepare a dedicated line for the connection of the
Transmitter in accordance with the regulations in
force on electrical equipment.
WARNING
Install the Transmitter at about 1.5 m above
the ground in a suitable position so as to measyre the
room temperature correctly, avoiding installation in
niches, behind doors, curtains, close to heat sources,
directly exposed to sunlight or water.
Proceed as follows:
DANGER
Cut off the voltage from the main switch.
1) Fit the two non-polarized ends of the connection
cable into the dedicated contacts present on the
fixing jig of the Transmitter (see 1-fig.1).
2) Remove the rear fixing jig from the Transmitter
and apply a slight pressure onto the top tab (see
2-fig.1) and secure it using the dedicated holes, in
a built-in box by means of the screws supplied and
taking care to follow the "UP" sign.
3) Fasten the Transmitter to the fixing jig, fitting
the bottom and pinning to the same until it closes
completely (see 3-fig.1).
6
CLOUDWARM WIRED - RAD - ING - Manual - 1606.1
1. INSTALLATION
1
2
3
fig. 1