Dantherm HCV 400 Manuel D'entretien page 28

User interactions, continued
Control panel
modes, continued
LAN interface
(Ethernet)
Fan speed level indicator
28
Button Mode
Filter or er-
ror display
HCV 400 is supplied with an Ethernet connection for the reading and checking of
the unit's operation via a BMS system . Every unit must have its own IP address on the com-
puter network to identify the unit .
IP adress Description
allocation status
Dynamic allocation If the unit is connected to a router with built-in DHCP server it will
fetch the IP address itself from the router when the unit starts up .
Static allocation Using PC-Tool it is possible to allocate a static IP address to the unit,
which is necessary for example in order to perform checks on HCV
400 via smartphone app when outside the LAN's range . This will also
require setup of the home's WAN address as well as allocating a port
on the router .
Description
This button is an alarm reset . If the LED lights orange this is a
warning that the filter needs changing . See page 29 for infor-
mation on changing filters .
• Press once to reset the filter alarm .
• Press and hold for 10 seconds to reset the filter timer without
the timer having expired .
If the LED is red, the unit is in a alarm state, that needs to be cor-
rected, in order to bring the unit into operation again .
Alarm reset:
• Clean/ replace filter (orange)
Error codes can be read on the remote control if connected, or in
• alarms (red)
the Dantherm PC tool .
Main mode:
• Week program
• Demand mode