Installation; Warranty Claims; Installation Considerations - Dantherm HCV 400 Manuel D'entretien

Installation

Introduction

Warranty claims

Transport and
unwrapping
Installation
considerations
18
This section will guide you through unpacking, mounting and installation .
Using a device outside the specified conditions and contrary to its designated use will lead
to the forfeiture of all warranty claims . Warranty is restricted to units, installed by trained and
certified personnel only .
Step Action
1 Report any obvious damage to the carrier, parcel service, postal service etc . immedi-
ately on delivery and note down the damage on the shipping document or carrier's
document .
Remove the packaging material completely (without using a knife) and dispose of
2
according to the local regulations .
3 Check the content of the box . The scope of delivery includes:
• HCV 400 unit
• 1x Wall bracket
• 2x Spacers
• 1x Drain hose
4 Should any transport damage be detected after unpacking of the device, or should
the delivery be incomplete, contact your salesman in charge or specialised dealer
without delay .
The following should be considered selecting an appropriate location for installation:
• Verify whether installation mode A (Standard) or B (Optional) is feasible for the installation
site . If mode B is preferred, follow the swopping procedure on page 16 .
Note: The swapping function between mode A and B provides ability to route the pair of
ducts (outside or inside) towards the unit from the left OR the right, according to building
and room construction . See the difference between the two modes in the "Overall descrip-
tion" on page 8 .
• The HCV 400 unit is designed to be mounted in dry surroundings, with temperatures
>12°C, utility room or similar heated rooms .
• Allocate additional space, to ensure correct mounting and serviceability .
• Ensure that the walls structure is adequate to support the weight of the unit, regardless of
bracket type .