Emerson CARRERA CF784BS01 Manuel Du Propriétaire page 7

Installation of Switch Housing
Assembly for Manual Control
3.6
Remove and retain the three #8-32 x 12mm flat head
screws from the switch housing plate.
Engage the connector of the switch housing assembly with
the motor connector (Figure 6).
The two connectors are keyed and color-coded and must
be mated correctly (color-to-color) before they can be
engaged.
Make sure the connector latch closes properly.
Installation of Switch Housing
Assembly for Manual Control
3.7
Carefully tuck all wires and connectors under the switch
housing assembly.
Secure the switch housing assembly by reinstalling the
three #8-32 x 12mm flat head screws (previously removed)
(Figure 7).
Proceed to Ceiling Fan Assembly, Step 3.9.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the switch housing assembly and the switch
housing plate.
Installation of Switch Housing for
Accessory Control
If Emerson Accessory RF Control is to be used, install
the accessory control switch housing.
3.8
Remove and retain the three #8-32 x 12mm flat head
screws from the switch housing plate.
Position the switch housing on the switch housing adapter
and align the holes in the switch housing with the holes in
the adapter.
Secure the switch housing by reinstalling the three
#8-32 x 12mm flat head screws (previously removed)
(Figure 8).
Proceed to Ceiling Fan Assembly, Step 3.9.
3. Ceiling Fan Assembly
7
Figure 6
SWITCH
HOUSING
ASSEMBLY
REINSTALL THE #8-32 x 12mm
FLAT HEAD SCREWS (3)
Figure 7
SWITCH
HOUSING
#8-32 x 12mm FLAT
HEAD SCREWS (3)
Figure 8
Please contact 1-800-654-3545 for further assistance
PULL CHAIN SWITCH
MOTOR
CONNECTOR
SWITCH HOUSING
ASSEMBLY
CONNECTOR
SWITCH HOUSING
ASSEMBLY
SWITCH HOUSING
ADAPTER
emersonfans.com
U.L. Model No.: CF784-1