Trouble Shooting - Emerson CARRERA CF784BS01 Manuel Du Propriétaire

WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
!
TROUBLE SHOOTING YOUR FAN.
TROUBLE
1. Fan will not start.
2. Fan sounds noisy.
3. Fan wobbles
excessively.

11. Trouble Shooting

PROBABLE CAUSE
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan,
or loose switch wire connections in the
switch housing.
3. Reversing switch in neutral position.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Screws securing fan blade flanges to
motor hub are loose.
4. Wire connectors inside switch housing
rattling.
5. Screws holding blades to flanges are
loose.
1. Setscrew in motor coupling is loose.
2. Setscrew in hanger ball / downrod
assembly is loose.
3. Screws securing fan blade flanges to
motor are loose.
4. Fan blade flanges not seated properly.
5. Hanger bracket and / or ceiling outlet
box is not securely fastened.
6. Fan blades out of balance.
SUGGESTED REMEDY
1. Check main and branch circuit fuses or circuit
breakers.
2. Check line wire connections to fan and switch
WARNING: Make sure main power is turned
wire connections in the switch housing.
!
OFF.
3. Make sure reversing switch position is all the
way to one side.
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor housing
are snug (not over-tight).
3. Check to make sure the screws which attach
the fan flanges to the motor hub are tight.
4. Check to make sure wire connectors in switch
housing are not rattling against each other or
against the interior wall of the switch housing.
WARNING: Make sure main power is turned
!
OFF.
5. Tighten screws securely.
1. Tighten both setscrews securely in the motor
coupling.
2. Tighten the setscrew in the hanger ball / downrod
assembly.
3. Check to be sure screws which attach the fan
blade flanges to the motor are tight.
4. Check to be sure the fan blade flanges seat
firmly and uniformly to the surface of the motor.
If flanges are seated incorrectly, loosen the
flange screws and retighten according to the
procedure in the section on "Ceiling Fan Assembly".
5. Tighten the hanger bracket screws to the outlet
box, and / or secure outlet box.
6. Interchanging an adjacent (side-by-side) blade
pair can redistribute the weight and result in
smoother operation.
20
U.L. Model No.: CF784-1