Luminance Brands kathy ireland HOME PREMIUM SELECT ECO CF4802AP00 Mode D'emploi page 10

3. Ceiling Fan Assembly
3.12
Reinstall the Hanger Ball on the Downrod as follows:
Route the Six 80-inch Motor Wires through the Hanger
Ball and slide the Hanger Ball over the Downrod
(Figure 12) .
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 12) .
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball .
NOTE: A loose set screw could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure
to verify that the pin and set screw are properly
installed could result in the fan falling.
3.13
The Fan comes with Blue, White, Grey, Red, Orange,
and Yellow Wires that are 80-inches long .
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 13) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
You have now partially completed the assembly of
your new Ceiling Fan, proceed to "How to Hang Your
Ceiling Fan" . Final Assembly of the Ceiling Fan will be
completed once Ceiling Fan is Hung and Wired .
(Continued)
PIN
HANGER BALL
DOWNROD
Figure 12
6 TO 9
INCHES
1/2
INCH
DOWNROD
Figure 13
10
SET SCREW
YELLOW WIRE
GREY WIRE
ORANGE WIRE
RED WIRE
BLUE WIRE
WHITE WIRE
U.L. Model No.: CF4802 and CF4502