Installation Instruction for Mounting Under the Cabinet
1
Lift the hood to the cabinet.
2
Fix the Hood Body with 4 screws from
the bottom.
14
6 x 14
3
Mark the wall where indicated.
Drill directly into ø 5/16" holes at all the center
points marked.
Insert the purchased wall plugs in the holes.
Using two remaining screws to anchor the hood
in holes.
4
Non Ducted - Recirculation Option
12e
For Non-Ducted Recirculation venting route the
ductwork to a location above the hood where the
discharge is vented back into the room.
Use the included Recirculation Vent Grill (8) to
cover the opening. Secure the grill with the 2 screws
(12e) provided in the Install Kit.
12a + 13
8